2007 FLTR Control Wiring

[FLHRCI]

My neighbor was extending the wiring on his road glide and pulled all the wires out of the connector, most bikes this is not to big a problem, but on his bike the right control harness has three Orange w/ White striped wires and the left set has two orange with white striped wires. I am just scratching my head here and we are leaving for a 1000 mile trip on Friday morning!

[aceharleywrench]

Orange with a white tracer is switched 12 volts (on & off with the key) What do you need to know?

[FLHRCI]

I have three orange w/ white tracers going in and coming out, i dont know which orange wire going in matches to which orange wire going out?

[aceharleywrench]

Doesn't matter,orange & white is always switched power,you can hook them up any way you like as long as it's orange & white to orange & white

[FLHRCI]

I am not getting 12 volts on these wires less than one volt on all of them and all the fuses are good.

[aceharleywrench]

Originally Posted by FLHRCI

I am not getting 12 volts on these wires less than one volt on all of them and all the fuses are good.

Well,then you have a problem! The O/W wires power the brake switch,the turn signal switch & the set/resume switch on the right side,on the left side O/W powers the horn switch,the turn signal switch & the cruise power switch.If you don't have 12 volts to the O/W wire you need to start tracing what you did.Check the taillamp connector & see if you have power there & work your way upstream.Good luck.

[Gunnert]

Don't mean to be a smart A__, but you need to buy a Service Manual from the dealer. If you are going to wrench, you need it. The first thing I buy when I get a new bike is the Service Manual AND the parts manual. After a while you'll find yourself using the parts manual more than the service manual.

[FLHRCI]

Thank you for all the help, he had a short we found it now all is resolved. Thanks Again!

[HotRodad1]

...and you did it with out a service manual!!!
cheers!