I noticed a spot of oil on my floor. As my Road King has not done this in the past I took a closer look and found a lot of oil underneath where the clutch cable enters the engine. Any ideas? I am not a wrench, but would be willing to save a few bucks and do the work myself if its not to hard. Dennis
You might try tightening the connection but be careful I snapped that puppy easily by going just that little bit too far when I was replacing my side cover. Ended up replacing the clutch cable then. There is also an o-ring inside that might need to be changed. That will entail removing the side cover and you'll need a new side cover gasket if you decide to go that route. Good luck.
seepage around clutch cable 
Linear Mode
